Rice socks are probably the best things ever for me because of my migraines. Just pop it in the microwave for a minute or so. Put it on your hurt, and presto you have wonderful soothing warmth right where you need it. So with the ever present question of what to make with all my Spoonflower swatches, this was the first thing I thought of. Top view A quick and simple swatch project: rice sock! 1. Measure swatch into thirds. Be sure and only measure the patterned portion. 2. Fold one end to the middle along measured line.( The doubled portion of the swatch will be on the outside at the end, and the bit hanging off the top will not be visible.) Sew along the line that you have measured above, or if you can see through the fabric just sew along the end of the design. 3. Fold the small white portion down and iron. Then flip it over and fold the large portion down an iron the same way. 4. Cut off any of the large portion that hangs over the edge. 5. Fold in raw edg...
Significant Otters Design Challenge If you’ve ever watched two otters holding hands (oh yes, it exists!) it’s safe to say this mammal has won the hearts of viewers with their otterly adorable appearance. This week we challenge you to win the hearts of the community with an otter-inspired design. There wasn't much direction on this contest. So I went in my own direction and finally ended up with Otter Lace . The lace was a fairly simple thing to create. The design is mirrored, which means I only had to draw the one half before the computer did the other side. The plan for the scalloped edge was to have it much wider in the middle section, but I decided the single flower between the otter couples looked better in the main motif. The fancy edge was digitally trimmed to match, and the rest of the computer work was spent on the colors. I also played around with a soft teal color with warm gray for a second version of the lace. ...
Finished Gator Supplies : Fat quarter of Sew a Gator! fabric Stuffing Needle Embroidery Floss Thread Strait pins Scissors Here's the fat quarter all printed up and beautiful, and the obvious first step is to cut out all the pieces leaving the white borders attached. Along the top of the gator there are printed guidelines for embroidering. They are white in the photo above, but have since been changed to black. Down the back I used a braided chain stitch , but you can use whatever embroidery stitch you are comfortable with. The website I used for the braided chain stitch has a wonderful stitch library that you can look through. Satin stitch the eyes and use a simple backstitch on the nostrils. I used 4 strands of a light yellow embroidery floss for everything, and 6 strands of black embroidery floss for the pupils. Here's the finished embroidery. Now put the mouth piece face down on top of the embroidered piece, and ...
Comments
Post a Comment